01
Emergency Call
You call, we ask three questions: where is the water showing, when did it start, and is it still active. If the leak is running, we talk you through shutting it down, moving furniture, and putting a bucket under the drip. For active water, we roll a 24/7 roof leak damage restoration in Aberdeen, Washington crew as fast as we can get there.
02
Leak Detection
We inspect the attic first, then the roof deck. A moisture meter and infrared thermal camera find wet zones that look dry to the eye. If the source is still unclear, we run a hose test kit over suspect areas until the water shows itself. Most detections take 45 to 90 minutes.
03
Roof Repair
Once we know the source, we fix it. That means new flashing, a replacement pipe boot, fresh roof sealant, or shingle replacement. We use roofing nail gun and pry bar work you would expect, and we match materials to what is already on your roof so the repair blends in.
04
Interior Restoration
We remove wet insulation, set drying equipment, and treat framing. Stained ceiling drywall gets cut out and replaced. We prime and paint to match. Depending on the size of the affected area, interior work runs one to four days, and we check moisture readings daily before we call it dry.
05
Final Walkthrough
We walk the attic and the repaired room with you, show you the moisture readings, and explain what to watch for over the next rainy season. You get photos of the repair, the material warranties, and our workmanship warranty in writing before we pack up.