Water staining and soft spots on the soffit
We trace the water to its entry point, replace the damaged soffit panel, clear the vents, and seal the joint above it. A hose test confirms the fix before we close up the eave.
Licensed, insured, and local to Grays Harbor County
Fascia and Soffit Leak Repair Aberdeen WA You Can Count On
When water runs behind your fascia boards and soaks the soffit, we stop it at the source. Our fascia and soffit leak repair Aberdeen WA service covers everything from failed gutter sealant to cracked pipe boots, and we handle fascia and soffit leak fixing in Aberdeen for homeowners across Grays Harbor County. We test with a hose kit before we leave, so you know the repair holds.
Careful work. Honest options.
About this service
What Fascia and Soffit Leak Repair Aberdeen WA Really Involves
Fascia and soffit leak repair Aberdeen WA is the trade of finding where water gets behind the boards that cap your rafter tails and the panels that vent your roof overhang, then sealing that path and replacing anything rotted. We check the gutter line, the drip edge, the roof underlayment above it, and the flashing where the wall meets the roof. A moisture meter tells us how far the wet zone reaches before we cut.
Aberdeen gets rain on and off from October through May, and that steady moisture finds every gap in a fascia board. If you have searched for fascia and soffit leak repair near me Aberdeen, you have probably already seen the paint blistering or a dark stain on the soffit. We also handle fascia and soffit leak repair service Aberdeen calls after a windstorm peels back a shingle and opens the edge of the roof.
- ✓ Stop Rot Before It Spreads
- ✓ Protect Gutters and Downpipes
- ✓ Keep Attic Moisture Down
- ✓ Avoid Emergency Roof Leak Repair Aberdeen WA
What's included
What Our Fascia and Soffit Leak Repair Includes
Every fascia and soffit leak repair Aberdeen WA job starts with detection and ends with a hose test. Here is what is covered in a standard repair, and what we quote separately if we find it.
✓
Full Roof Edge Inspection
We inspect the fascia, soffit, gutter line, drip edge, and the first course of roofing above it. A moisture meter and infrared thermal camera map the wet zone so we cut only what is damaged.
✓
Leak Detection and Hose Testing
We reproduce the leak with a hose test kit on the gutter, downpipe connectors, and roof edge. That confirms the entry point before we open anything up, which keeps the repair focused and the cost down.
✓
Rotted Fascia Removal and Replacement
Soft or cracked fascia boards come off, the rafter tail is treated, and new boards go on with a roofing nail gun. We match the profile and paint so the repair blends with the rest of the eave.
✓
Soffit Panel and Vent Repair
We replace water-damaged soffit panels and clear blocked vents so the attic can breathe. Good intake airflow is what keeps attic moisture from climbing after a Grays Harbor rain.
✓
Sealing, Flashing, and Waterproofing
Joints get Sika or Tremco roof sealant, the roof-to-wall transition gets new flashing, and the eave gets Grace Ice & Water Shield. On flat sections we roll on a Henry Company roof coating.
✓
Gutter Re-Hang and Final Test
We re-secure the gutter with new hangers and gutter sealant, then run the hose one more time over every repaired joint. If it is dry, we clean up and haul away the old material.
How it works
How Our Fascia and Soffit Leak Repair Process Works
01
Roof Edge Inspection
We walk the gutter line with a moisture meter and an infrared thermal camera to map the wet zone. If the leak source is above the fascia, we send the roof inspection drone up for a look at the drip edge and the first course of shingles. You get photos of what we find.
02
Leak Detection and Testing
We use a hose test kit on the gutter, the downpipe connectors, and the roof edge to reproduce the leak while we watch from below. That tells us whether the water is coming from a failed gutter seam, a cracked pipe boot, or a gap behind the flashing. No guesswork.
03
Repair and Replacement
We pry off the damaged fascia, cut back the rot, and install new boards with a roofing nail gun. Soffit panels come out if they are soft. We seal the joints with Sika or Tremco roof sealant and re-hang the gutter with new hangers and gutter sealant.
04
Waterproofing the Edge
We install Grace Ice & Water Shield behind the fascia where the roof meets the wall, then set new flashing and drip edge. On flat sections we roll on a Henry Company roof coating. This is the layer that keeps Aberdeen rain from finding the same path next season.
05
Final Hose Test and Cleanup
We run the hose again over every repaired joint and watch for drips. If it is dry, we clean the gutter, haul away the old material, and walk you through what we did. You get a warranty on the work and a maintenance note for the spring.
Tools & methods
Tools and Methods We Use on Every Repair
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Moisture Meter
Reads the water content in fascia boards and soffit panels so we know exactly how far the wet zone reaches before we cut.
Infrared Thermal Camera
Shows temperature differences behind the boards, which reveals hidden moisture paths that are invisible from the outside.
Roof Inspection Drone
Lets us look at the drip edge, flashing, and first course of shingles above the fascia without putting a ladder on wet ground.
Hose Test Kit
Reproduces the leak on the gutter, downpipe connectors, and roof edge so we can confirm the entry point before we open the eave.
Caulking Gun and Roof Sealant
Applies Sika and Tremco sealants to fascia joints, gutter seams, and flashing edges at a controlled bead width.
Roofing Nail Gun and Pry Bar
Speeds up fascia replacement and lets us remove damaged boards and flashing without splitting the rafter tails.
Ladder Stabilizer and Pitch Hoist
Keeps ladders secure on uneven ground and helps us move heavy materials up to the eave safely.
Real results
Before and after.
Soggy Soffit in Rosemount
Before
A homeowner in Rosemount had a brown stain spreading across the soffit every time it rained. The fascia board behind the gutter was soft to the touch and the gutter had pulled away from the eave by about an inch.
After
We replaced two fascia boards, reset the gutter pitch, and installed new hangers with gutter sealant. The soffit panel was replaced and the vents cleared. A hose test ran dry, and the stain has not returned through two wet seasons.
Storm-Damaged Eave in Garthdee
Before
A windstorm peeled shingles off the eave of a Garthdee home and exposed the underlayment. Water ran behind the fascia for a week before the owner called, and the rafter tail had started to soften.
After
We tarped the edge the same night, then rebuilt it with new shingles, Grace Ice & Water Shield, and a new drip edge. The rafter tail was treated and sistered, and the fascia was replaced. The repair passed a hose test and a follow-up inspection.
Cracked Pipe Boot in Ferryhill
Before
A Ferryhill homeowner had attic moisture and a drip on the porch that they assumed was a gutter problem. The gutter was fine. The actual source was a cracked pipe boot higher up the roof, sending water down the deck to the fascia.
After
We replaced the boot, resealed the collar, and repaired the fascia joint where the water had been running. The soffit vents were cleared and the attic dried out. The porch drip stopped the same day.
Problems we solve
Fascia and Soffit Leak Problems We Solve in Aberdeen
Most fascia leaks in Aberdeen trace back to one of a handful of causes. Here is what we see on roof edges around Grays Harbor County and how we fix each one.
Ask a pro →↗
Gutter pulling away from the fascia
We replace any rotted fascia behind the hangers, reset the gutter pitch, and install new hangers with gutter sealant on the seams. The run gets tested with water before we leave.
Cracked pipe boots and failed vent collars
We replace the boot or collar, reseal it with roof sealant, and check the fascia and soffit for water that tracked down from above. Detection first means we fix the right spot.
Missing shingles at the roof edge
We replace the missing shingles, renew the ice and water shield, and re-secure the drip edge. Then we inspect the fascia for rot and replace any board that has gone soft.
Proof you can check
Licensed, Certified, and Local
✓
Washington State Roofing Contractor LicenseWashington State Department of Labor & Industries
✓
WA L&I Contractor RegistrationWashington State Department of Labor & Industries
✓
GAF Master Elite CertificationGAF
✓
Owens Corning Preferred ContractorOwens Corning
✓
EPA Lead-Safe Certified FirmU.S. Environmental Protection Agency
Customer reviews
What Aberdeen Homeowners Say
★★★★★
“We had a stain spreading across the soffit every time it rained. The crew hosed the gutter, found a failed seam, and showed me the wet fascia on camera. They replaced two boards, resealed the gutter, and tested it before they left. That was last November and the soffit is still dry.”
MR
Marta R.Homeowner, Rosemount
✓ Verified“
★★★★★
“A windstorm peeled shingles off the eave and water ran behind my fascia for a week. They tarped it the same night I called, then came back and rebuilt the edge with new flashing and ice and water shield. The price matched the quote to the dollar.”
DK
Dale K.Homeowner, Garthdee
✓ Verified★★★★★
“I thought the leak was the gutter, but they traced it to a cracked pipe boot higher up. They replaced the boot, sealed the fascia joint, and cleared the soffit vents. No more attic moisture and no more drips on the porch. Straight answers the whole way.”
PS
Priya S.Homeowner, Ferryhill
✓ VerifiedMost fascia and soffit leak repairs in Aberdeen run $350 to $1,400 in 2026, depending on how much rot we find and whether the gutter has to come down. A single failed gutter seam with a dry fascia is often under $400. If the rafter tail is soft and we replace boards, expect the middle of that range. We give you a written price before we start.
You find the water path first, then fix the cause. We hose-test the gutter, the downpipe connectors, and the roof edge to see where water enters. Then we cut out rotted fascia, install new boards, seal the joints with roof sealant, and reset the flashing and drip edge. Skipping the detection step is why most DIY patches fail by the next storm.
We do. Aberdeen Roof Leak Repair Pros handles fascia and soffit leak fixing in Aberdeen, Washington and across Grays Harbor County, including Torry, Ferryhill, Rosemount, and Garthdee. We are licensed, insured, and we carry WA L&I Contractor Registration. Call +13608991171 and we will schedule a same-day look at your roof edge.
Yes. Water that gets behind the fascia wicks into the rafter tail, the roof deck, and the top plate of the wall. In Aberdeen, where rain runs from October through May, that moisture feeds rot and attic moisture, and it can loosen the gutter so it pulls away from the roof. Catching it at the first board usually saves the deck.
More services
Related Services
Roof Leak RepairFascia leaks often start higher up. If the drip edge or the first course of shingles is the source, our roof leak repair crew fixes the roof surface so water stops reaching the fascia in the first place.Explore →
Emergency Roof Leak RepairWhen a storm opens your roof edge and water is running into the soffit, we tarp and stop the active leak first, then schedule the permanent fascia and soffit repair for the next dry window.Explore →
Roof Leak DetectionWe use a moisture meter, an infrared thermal camera, and a hose test kit to find the exact entry point before we cut into your fascia. Detection first means we repair the right board, not the nearest one.Explore →
Flat Roof Leak RepairFlat and low-slope sections on Aberdeen homes pond water against the roof edge. We repair the membrane and add a Henry Company roof coating so the fascia below stays dry through the wet season.Explore →
Slate Roof Leak RepairSlate roofs shed water well until a tile slips and exposes the underlayment at the edge. We reset the slate, replace the flashing, and check the fascia for rot caused by the hidden leak.Explore →
Tile Roof Leak RepairClay and concrete tiles can crack at the eave and let water run behind the fascia board. We replace the damaged tiles, renew the underlayment, and seal the roof edge so the gutter line stays dry.Explore →
Metal Roof Leak RepairMetal roof panels expand and contract, which loosens fasteners at the eave. We reseal the seams with Sika, replace the washers, and check the fascia and soffit for water that tracked behind the panel.Explore →
Shingle Roof Leak RepairMissing shingles at the roof edge are a common cause of fascia leaks in Aberdeen. We replace the shingles, renew the ice and water shield, and re-secure the drip edge above the fascia.Explore → Ready when you are
Get Your Fascia and Soffit Leak Repair Aberdeen WA Scheduled
We are licensed, insured, and we answer the phone 24/7. Call +13608991171 and we will get eyes on your roof edge today, with a written price before any work starts.
Book a Repair +13608991171 →
Request an appointment
Contact Aberdeen Roof Leak Repair Pros
Call +13608991171 and tell us where the water is showing up. We answer the phone, ask the right questions and give you a real arrival window. Active leaks get priority, and most addresses inside 98520 see a crew the same day. You can also email [email protected] with photos of the stain or the roof.